USDA Generic HACCP Model for meat United states Department of griculture and Poultry Food Safety and Inspection Products with Service September 199 Secondary HACCP-9 Inhibitors, not Shelf Stable
United States Department of Agriculture Food Safety and Inspection Service September 1999 HACCP-9 Generic HACCP Model for Meat and Poultry Products with Secondary Inhibitors, Not Shelf Stable
Additional copies of the Guidebook for the Preparation of haccP plans and the generic hAcCP Models are available from U.S. Department of Agriculture Food Safety and Inspection Service(FSIS) Office of Policy, Program Development and Evaluation(OPPDE) Inspection Systems Development Division Room 202, Cotton Annex Building 300 Street sw Washington. D.C. 20250-3700 Phone:(202)720-3219 Fax:(202)690-0824 This material is also available on the FSis Homepage http://www.fsisusdagov/index.htm
Additional copies of the Guidebook for the Preparation of HACCP Plans and the Generic HACCP Models are available from: U.S. Department of Agriculture Food Safety and Inspection Service (FSIS) Office of Policy, Program Development, and Evaluation (OPPDE) Inspection Systems Development Division Room 202, Cotton Annex Building 300 12th Street SW Washington, D.C. 20250-3700 Phone: (202) 720-3219 Fax: (202) 690-0824 This material is also available on the FSIS Homepage: http://www.fsis.usda.gov/index.htm
Products with Secondary Inhibitors, Not Shelf stable model Table of contents Introduction Using This Generic Model Process Flow Diagram and product Descripti Hazard analysis Developing Your HACCP Plan 10 Identifying CCPs appendix a References for HACCP teams 17 References for Meat and Poultry Products with Secondary Inhibitors Not shelf stable appendix b Process Flow Diagram(Figure 1)Corned Beef Product Description Form(Figure 2)Corned Beef Hazard analysis Form( Figure 3) HACCP Plan Form(Figure 4) Form Letter Confirming Salmonella Compliance with Performance Standards Thermometer Calibration Log Weight/Formulation Record L 35
Products with Secondary Inhibitors, Not Shelf Stable Model Table of Contents Introduction……………………………………………………………………………..…. 3 Using This Generic Model…………………………………………………………..…….. 5 Process Flow Diagram and Product Description…………………………………..………. 7 Hazard Analysis………………………………………………………………….…………8 Developing Your HACCP Plan………………………………………………..….……….. 10 Identifying CCPs……………………………………………………………………..……. 11 Appendix A References for HACCP Teams……………………………………..…………….. 17 References for Meat and Poultry Products with Secondary Inhibitors, Not Shelf Stable …………………………………………………………..……..… 19 Appendix B Process Flow Diagram (Figure1) Corned Beef ………………………….………… 22 Product Description Form (Figure 2) Corned Beef ……………………………… 23 Hazard Analysis Form (Figure 3)……………………………………………….…. 24 HACCP Plan Form (Figure 4)…………………………………..……………….… 28 Form Letter Confirming Salmonella Compliance with Performance Standards ……………………………………….…………………………………. 32 Thermometer Calibration Log…………………………………………………….. 33 Weight/Formulation Record………………………………………………………. 34 Pump Percentage Log……………………………………………………………… 35 1
Products with Secondary Inhibitors, Not Shelf stable Model Generic Establishment X: Room Temperature Log 36 Corrective Actions Log Pre-Shipment Review Log
Products with Secondary Inhibitors, Not Shelf Stable Model Generic Establishment X: Room Temperature Log …………………………….… 36 Corrective Actions Log……………………………………………………………. 37 Pre-Shipment Review Log………………………………………………………… 38 2
Products with Secondary Inhibitors, Not Shelf stable model GENERIC HACCP MODEL FOR MEAT AND POULTRY PRODUCTS WITH SECONDARY INHIBITORS NOT SHELF STABLE Introduction The Hazard Analysis Critical Control Point(HACCP)system is a scientific approach to process control. It is designed to prevent the occurrence of problems by assuring that controls are applied at any point in a food production system where hazardous or critical situations could occur. Hazards include biological, chemical, or physical contamination of food products The Food Safety and Inspection Service(FSIS) published a final rule in July 1996 mandating that haCCP be implemented as the system of process control in all inspected meat and poultry plants. As part of its efforts to assist establishments in the preparation of plant-specific HACCP plans, FSiS determined that a generic model for each process defined in the regulation would be made available for use on a voluntary basis by inspected establishments The generic models have been revised since their initial publication and distribution as DRAFTS. The most important change in the revised versions is to make certain that these models are fully consistent with the features of the final regulation. Also, other technical and editorial improvements have been made Throughout this generic model, FSiS discusses a haCCP team with members from different departments. In many very small establishments, there will not be separate departments with different employees. But, there will be employees who perform these different functions -often several of them. For purposes of explaining concepts, it is easier to speak as if these were different people, even though in many cases, they may be the same person carrying out more than one responsibility Each generic model can be used as a starting point for the development of plant-specific plan(s) reflecting actual plant environments and the processes conducted. The generic model is not intended to be used"as is" for plant specific HACCP plans in the hACCP regulations in section /s In conjunction with the list of process categories found The generic models are designed for use 2(b)(1)
Products with Secondary Inhibitors, Not Shelf Stable Model GENERIC HACCP MODEL FOR MEAT AND POULTRY PRODUCTS WITH SECONDARY INHIBITORS, NOT SHELF STABLE Introduction The Hazard Analysis Critical Control Point (HACCP) system is a scientific approach to process control. It is designed to prevent the occurrence of problems by assuring that controls are applied at any point in a food production system where hazardous or critical situations could occur. Hazards include biological, chemical, or physical contamination of food products. The Food Safety and Inspection Service (FSIS) published a final rule in July 1996 mandating that HACCP be implemented as the system of process control in all inspected meat and poultry plants. As part of its efforts to assist establishments in the preparation of plant-specific HACCP plans, FSIS determined that a generic model for each process defined in the regulation would be made available for use on a voluntary basis by inspected establishments. The generic models have been revised since their initial publication and distribution as DRAFTS. The most important change in the revised versions is to make certain that these models are fully consistent with the features of the final regulation. Also, other technical and editorial improvements have been made. Throughout this generic model, FSIS discusses a HACCP team with members from different departments. In many very small establishments, there will not be separate departments with different employees. But, there will be employees who perform these different functions – often several of them. For purposes of explaining concepts, it is easier to speak as if these were different people, even though in many cases, they may be the same person carrying out more than one responsibility. Each generic model can be used as a starting point for the development of plant-specific plan(s) reflecting actual plant environments and the processes conducted. The generic model is not intended to be used “as is” for plant specific HACCP plans. The generic models are designed for use in conjunction with the list of process categories found in the HACCP regulations in section 417.2(b)(1). 3