USDA Generic HACCP Model for United states Department of griculture Irradiated raw Food Safety and Inspection Meat and Service May 1999 Poultry HACCP-8 Products
United States Department of Agriculture Food Safety and Inspection Service May 1999 HACCP-8 Generic HACCP Model for Irradiated, Raw Meat and Poultry Products
Additional copies of the Guidebook for the Preparation of haccP plans and the generic hAcCP Models are available from U.S. Department of Agriculture Food Safety and Inspection Service(FSIS) Office of Policy, Program Development and Evaluation(OPPDE) Inspection Systems Development Division Room 202, Cotton Annex Building 300 Street sw Washington. D.C. 20250-3700 Phone:(202)720-3219 Fax:(202)690-0824 This material is also available on the FSis Homepage http://www.fsisusdagov/index.htm
Additional copies of the Guidebook for the Preparation of HACCP Plans and the Generic HACCP Models are available from: U.S. Department of Agriculture Food Safety and Inspection Service (FSIS) Office of Policy, Program Development, and Evaluation (OPPDE) Inspection Systems Development Division Room 202, Cotton Annex Building 300 12th Street SW Washington, D.C. 20250-3700 Phone: (202) 720-3219 Fax: (202) 690-0824 This material is also available on the FSIS Homepage: http://www.fsis.usda.gov/index.htm
Irradiated Ram Model Table of contents Introduction Using This Generic Model Process Flow Diagram and Product Description 3578 Hazard analysis Developing Your HACCP Plan 10 Identifying CCPs Appendix a References for all haccp Model teams 19 References for Irradiated, Raw Meat and Poultry Products Appendix B Process Flow Diagram(Figure 1) Product Description Form( Figure 2) 26 Hazard analysis Form(Figure 3) 27 HACCP Plan Form(Figure 4) 32 Form letter requesting Salmonella data(1) Form letter requesting Salmonella data(2) Generic Establishment X: Product Temperature Lo Generic Establishment X: Room Temperature Log hermometer Calibration Log
Irradiated, Raw Model Table of Contents Introduction………………………………………….……………………………………. 3 Using This Generic Model………………………….…………………………………….. 5 Process Flow Diagram and Product Description….………………………………………. 7 Hazard Analysis…………………………………………………………………………… 8 Developing Your HACCP Plan………..………………………………………………….. 10 Identifying CCPs…………………………………….……………………………………. 12 Appendix A References for all HACCP Model Teams………………………………………… 19 References for Irradiated, Raw Meat and Poultry Products..…………………….. 21 Appendix B Process Flow Diagram (Figure 1)…………………………………………………. 25 Product Description Form (Figure 2)……………………………………………… 26 Hazard Analysis Form (Figure 3)…………………………………………………. 27 HACCP Plan Form (Figure 4)..…………………………………………………… 32 Form letter requesting Salmonella data (1)……………………………………….. 37 Form letter requesting Salmonella data (2)……………………….……………….. 38 Generic Establishment X: Product Temperature Log …………………………….. 39 Generic Establishment X: Room Temperature Log…………..…………………… 40 Thermometer Calibration Log………………………………………………..……. 41 1
Irradiated Ram Model Generic Establishment X: Irradiation/Dose Mapping Log Corrective Actions Log Pre-Shipment Review Log
Irradiated, Raw Model Generic Establishment X: Irradiation/Dose Mapping Log ……………………….. 42 Corrective Actions Log……………………………………………………………. 43 Pre-Shipment Review Log………………………………………………………… 44 2
Irradiated Ram Model GENERIC HACCP MODEL FOR IRRADIATED RAW MEAT AND POULTRY PRODUCTS Introduction The Hazard Analysis Critical Control Point(HACCP) system is a scientific approach to process control. It is designed to prevent the occurrence of problems by assuring that controls are applied at any point in a food production system where hazardous or critical situations could occur. Hazards include biological, chemical, or physical contamination of food products The Food Safety and Inspection Service(FSIS) published a final rule in July 1996 mandating that HACCP be implemented as the system of process control in all inspected meat and poultry plants. As part of its efforts to assist establishments in the preparation of plant-specific HACCP plans, FSiS determined that a generic model for each process defined in the regulation would be made available for use on a voluntary basis by inspected establishments The generic models have been revised since their initial publication and distribution as DRAFTS. The most important change in the revised versions is to make certain that these models are fully consistent with the features of the final regulation. Also, other technical and editorial improvements have been made Throughout this generic model, FSIS discusses a HACCP team, with members from different departments. In many very small establishments, there will not be separate departments with different employees. But there will be employees who perform these different functions -often several of them. For purposes of explaining concepts, it is easier to speak as if these were different people, even though in many cases, they may be the same person carrying out more than one responsibility Each generic model can be used as a starting point for the development of plant-specific plan(s) reflecting actual plant environments and the processes conducted. The generic model is not ntended to be used"as is"for plant specific HACCP plans The generic models are designed for use in conjunction with the list of process categories found in the HACCP regulations in section 417 2(b)(1
Irradiated, Raw Model GENERIC HACCP MODEL FOR IRRADIATED, RAW MEAT AND POULTRY PRODUCTS Introduction The Hazard Analysis Critical Control Point (HACCP) system is a scientific approach to process control. It is designed to prevent the occurrence of problems by assuring that controls are applied at any point in a food production system where hazardous or critical situations could occur. Hazards include biological, chemical, or physical contamination of food products. The Food Safety and Inspection Service (FSIS) published a final rule in July 1996 mandating that HACCP be implemented as the system of process control in all inspected meat and poultry plants. As part of its efforts to assist establishments in the preparation of plant-specific HACCP plans, FSIS determined that a generic model for each process defined in the regulation would be made available for use on a voluntary basis by inspected establishments. The generic models have been revised since their initial publication and distribution as DRAFTS. The most important change in the revised versions is to make certain that these models are fully consistent with the features of the final regulation. Also, other technical and editorial improvements have been made. Throughout this generic model, FSIS discusses a HACCP team, with members from different departments. In many very small establishments, there will not be separate departments with different employees. But there will be employees who perform these different functions – often several of them. For purposes of explaining concepts, it is easier to speak as if these were different people, even though in many cases, they may be the same person carrying out more than one responsibility. Each generic model can be used as a starting point for the development of plant-specific plan(s) reflecting actual plant environments and the processes conducted. The generic model is not intended to be used “as is” for plant specific HACCP plans. The generic models are designed for use in conjunction with the list of process categories found in the HACCP regulations in section 417.2(b)(1). 3