6.5 Cleaning the comyn oil/water Separater
6.5 Cleaning the Comyn oil/water Separater
6.5 Cleaning the Comyn oil/water Separater To clean out the separator ensure that all oil possible has been drawn off through the oil recovery valve and scum valve, and that the separator is full of water Turn on steam to heating coil; also steaming out connection, and allow the separator to become thoroughly hot Pump clean water slowly through the separator, and occasionally open oil recovery valve to free the separator of any oil that is present. Use hand control cock during this operation to open and close oil recovery valve as require
6.5 Cleaning the Comyn oil/water Separater • To clean out the separator ensure that all oil possible has been drawn off through the oil recovery valve and scum valve, and that the separator is full of water. • Turn on steam to heating coil; also steaming out connection, and allow the separator to become thoroughly hot. • Pump clean water slowly through the separator, and occasionally open oil recovery valve to free the separator of any oil that is present. Use hand control cock during this operation to open and close oil recovery valve as required
6.5 Cleaning the Comyn oil/water Separater Finally, open drain cock to bilge and continue to pump clean water into the separator for a short period. Close valve and leave the separator full of clean water at all times
6.5 Cleaning the Comyn oil/water Separater • Finally, open drain cock to bilge and continue to pump clean water into the separator for a short period. Close valve and leave the separator full of clean water at all times
6.5 Cleaning the Comyn oil/water Separater The automatic control system associated with all sizes of Comyn Separator consists of a transistorized level control unit, actuated by a probe mounted horizontally within the oil recover dome The level control unit which incorporates indicator lights is mounted together with an on/off fused switch, alarm bell and terminal box, on a suitable panel attached to the separator shell The control panel is sometimes mounted at some position away from the separator. The actuation of the level control unit directly governs the opening and closing of the diaphragm operated pressure closing type oil outlet valve. via a suitable solenoid pilot control valve which is also mounted on and pre-wired to, the control panel
6.5 Cleaning the Comyn oil/water Separater • The automatic control system associated with all sizes of Comyn Separator consists of a transistorized level control unit, actuated by a probe mounted horizontally within the oil recover dome. • The level control unit which incorporates indicator lights, is mounted, together with an ‘on/off’ fused switch, alarm bell and terminal box, on a suitable panel attached to the separator shell. • The control panel is sometimes mounted at some position away from the separator. The actuation of the level control unit directly governs the opening and closing of the diaphragm operated pressure closing type oil outlet valve, via a suitable solenoid pilot control valve, which is also mounted on and pre-wired to, the control panel
6.6 Coalescing bed-type oily water separators AIR ELIMINATORS RELIEF VALVE STEAM COIL ECONDARY ZONE PRIMARY WATER LIF TING LUC SCREEN 二3 STEAM COIL DRAIN PLUG /E DRAIN:: PLUG
6.6 Coalescing bed-type oily water separators