CUHK ARM7 board 2012 Serial <> USB IC Connect to computer Use power 8。0858 Supply (9v OR Use power NXP LPC2131 A simple prototype adapter board A Slide switch (Pull right is the programming mode; oog Pull left is the normal mode Always light up with power on Press to reset Sarm-00aRlM4
CUHK ARM7 board 2012 16 A simple prototype board Serial ↔ USB IC NXP LPC2131 Always light up with power on Press to reset Connect to computer Use Power Supply (9V) OR Use power adapter A Slide switch (Pull right is the programming mode; Pull left is the normal mode) CES arm board v.14.7
Install the serial<> USb driver After you power on and connect the board to computer, you may need to install the driver for the Serial <>USB chip Please download the driver from black Board. named CDM20828 Setupexe ou can also download the driver from this link http.://www.ftdichip.com/drivers/cp.htm Please install it, then, re-connect the board to computer Now, go to Device Manager to check the board can be recognize by the computer or not CES arm board v 14.7 17
Install the Serial ↔ USB driver • After you power on and connect the board to computer, you may need to install the driver for the Serial ↔ USB chip • Please download the driver from BlackBoard, named “CDM20828_Setup.exe” – You can also download the driver from this link http://www.ftdichip.com/Drivers/VCP.htm • Please install it, then, re-connect the board to computer • Now, go to Device Manager to check the board can be recognize by the computer or not CES arm board v.14.7 17