第一节拱桥的有支架施工 第二节拱桥的无支架施工 第三节拱桥的转体施工 第四节其他拱桥的施工

第一节拱桥的总体设计 第二节拱轴线形的选择和拱上建筑的布置 第三节拱桥主要尺寸的拟定 第四节拱桥上部构造体积计算(略)

第一节拱桥的发展及受力特点 第二节拱桥的组成和主要分类 第三节主拱圈的构造 第四节其他类型拱桥的构造特点 第五节拱上建筑的构造

10-1连续梁桥施工方法简介 10-2悬臂施工方法简介

10-1、悬臂和连续体系梁桥的一般特点 10-2预应力砼连续梁桥

Clutch Drum Housing for the clutch components A band may grab the outer surface of the drum Internal splines grab the clutch plates Check ball is used to relieve pressure trapped by centrifugal force

Camber Inward and outward tilt of the tires Tire wearing angle Negative when the top is tilted in degrees when vertical Typical ranges from 1/4 to 1/2 degree positive

Fifth Gear Output (don't worry about l1s one now, unique to @Qo⑨ the FORD MTX) Input Shaft Output shaft @ Cdol Final drive

Diferential Components Drive Pinion Differential Case Axle shaft Axle shaft Ring Gear Side gears

Clutch Operation With you foot off of the pedal, the pressure plate holds the clutch against the flywheel, allowing power to travel through the clutch to the input shaft of the transmission