New Connection Select a device and interface to connect to 路由器R1和R2之间通过 点到点的方式建立连接 Available Devices Ethernet Interfaces Host2 Device Name For Selected Device a Select Serial Connection Type Router 1 Please select the PHYSICAL Telco Connectivity connection you would like to make a Point to Point Serial connection(Serial Cable) This will be used to make normal point to point serial connections. When you proceed with this step you will be asked to select the device and < Back Cancel Finish interface you would like to connect on both sides. After you select the devices used you wi have to pick the dCe side of the serial connection This will be the side that you will have to provice clocking for when you load your topology into the simulator C Point to Multi-Point Serial Connection (Frame Relay) 主机1和路由器R1的E0 This wil allow you to make up to an 8 point full mesh frame connection. For each connectio you will need to specify the Router and 接口之间建立连接 interface to use from the list of ayailable device Cancel 计算机网络技术
计算机网络技术 6 主机1和路由器R1的E0 接口之间建立连接 路由器R1和R2之间通过 点到点的方式建立连接
y Connection Select a device and interface to connect to 连接R1的对端接口为 Available devices Serial Interfaces enal 0 R2的s0端口 Device Name For Selected device Router 2 Serial Connection-Cable select Please select the DCE side of the Serial Cable. This will be the side that will need clocking inside of the Back Cancel Finish Simulato 2. Serial 建立路由器R1和路由器R2 「R1.s0 之间的对端S0接口连接 OK 计算机网络技术
计算机网络技术 7 建立路由器R1和路由器R2 之间的对端S0接口连接 连接R1的对端接口为 R2的S0端口