2、在下面对话框中选择Port:CoM3端号口，然后点击Connect连接，出现disconnect，即可，如下图所示；XMW Add Device...Select settings for your device.5073A4（+/-10Disconnect口Port:CoM3Baud rate115200口口Bits:8bitEbitStop bits:口国Parity:NoneFlow control:offHardware InfoModule type:5073A411Calibrationdate:4/2016497866401:18Serial number:Software version:OnlineCancel<PreviousNext)Finish3.单击next，进入标定界面，如下图，按照标定证书，分别进行，chanell标定Fx，chanel2标定Fy，chanel3，标定Fz，设定好参数，每次都要send和load.如下图所示；XMw Add Device..Device SettingsChannelopythis Channel toall OtherOChannel OChanel OCharnelChannelBasic Charnel SettingsUnit:Newton [N]sensitivity:7.68pC/NScalingBasic Range SettingsMechanical RangeScale FactorCharge Full ScaleRange 1:499.85N49.98N/V3838.83pCRange 2:497.30N49.73N/V3819.29pCAdvanced Charnel Settings口Full scale output[0000mvoutput offset:+0.00mvPeak:offLow Pass Filter (all Charnels)Cut-off frequency:off10Hz200Hz3000HzSymchronisationSendLoadOnlineCancel<PreviousNext)Finish
2、在下面对话框中选择 Port:COM3 端号口，然后点击 Connect 连接,出现 disconnect,即可，如下图所示； 3．单击 next,进入标定界面，如下图，按照标定证书，分别进行，chanel1 标定 Fx，chanel2 标定 Fy，chanel3,标定 Fz,设定好参数，每次都要 send 和 load. 如下图所示；
XMwAddDevice..Device SettingsChannelopy this Channel to all OtherChannel OChannelCharnelOCharnelBasic Channel SettingspC/NUnit:Newton [N]sensitivity:7.65ScalingBasic Range Settingsechanical RangeScale FactorCharge Full ScaleN/VRange 1:499.25N49.923819.26pCNN/VpcRange 2:499.2549.923819.26Advanced Channel Settings口Full scale output 10000mvoutput offset:+0.00mPeak:OffLowPass Filter (all Charnels)200Hz10Hz3000HzCut-offfrequency:offSynchronisationSendLoadOnlineCancel<PreviousNext>FinishXMWAdd Device...Device SettingsChannelopy this Charnel toall OtherCharnelCharneloChannelCharnelBasic Channel SettingsUnit:Newton [N]sensitivity:3.62pC/NScalingBasic Range SettingsCharge Full ScaleMechanical RangeScale FactorN50.26N/VPCRange 1:502.57181930N/V34972179976pCRange 2:497.17Advanced Charnel SettingsAFull scale output10000mvoutput offset:+0.00mvPeak:OffLowPass Filter (all Charnels)200HzO10Hz3000HzCut-off frequency:offSymchronisationSendLoadOnlineCancel<PreviousNextFinish都完成以后，点击finish，即标定结束
都完成以后，点击 finish，即标定结束